|
Kansas | That is probably a 12 volt sensor. The Field IQ wiring is normally set up for 8 volt bin level sensors when it is using pins 5 (signal), 8 (8v+) and 10 (gnd) on the aux connector. You will most likely need to change the wire in pin 8 (8v+) to pin 2 or 3 (12v+ out) and things should work. The Raven sensor should be Pin A (12v+), Pin B (GND) and Pin C (Signal).
Edited by gps47 10/9/2020 08:40
| |
|