|
ne nebraska | Had tye 9870 at deere shop trying to fix autotrac. They narrowed it down to what they think is a broken wire going to the controller. They were assuming it was the can a or can b wire. I needed to take the combine, but would like to try to find broken where if possible. What route does that harness take to get under the cab? Any ideas where else to start looking or any other common areas that are trouble? I did see a mouse run across the floor of the cab when I bought the machine(2 weeks ago). Possible a mouse got a wire? They did a calibration on the autosteer and it passed calibration, so that part is good. The only other odd thing is the MPH indicator on the corner post reads zero all the time. Could it be related? The gps speed on the monitor works fine. Thanks in advance for the help.
Edit to add, after setting an AB line, and engaging autosteer, the monitor(2630) thinks autosteer is engaged. Everything turns green, but does not actually steer the combine. No codes thrown either
Edited by kaky9236 9/29/2020 18:22
| |
|