My auger will not raise. This is an issue that started last season and sometimes was not an issue. But often it would take activating the tractor remote multiple times to get the auger cylinder to work.
I do not think it’s an issue with the tractor, because all other cart functions are fine, and switching remotes doesn’t help. I can see oil pressure up at the rod end hole (the hoses going there) on the cylinder. There is some sort of valve thing on this cylinder, and I replaced it with a new one without success. I can’t quite figure out how the plumbing works on this cylinder.
Any ideas? Other than a bad cylinder, which I’ve never seen happen, I’m at a loss.