|
Saginaw Michigan | i believe e2 is the remote master switch input, e3 is steeper seed prime switch, e4 e5 reserved for future use. is e2 blackened? or green or grey?
if you have clutch control and hyd drive, make sure you have implement switch plugged into the hyd drive. priority for switch should be: stepper driver/hydr drive, then clutch control, then LCM, then app rate module... does it run if you plug the switch jumper stub in? did you tee into an existing switch? i did exactly that last week, and neglected to see that i was leaving an open circuit on other end where it plugged into the rawson....
just some thoughts
i hate those kind of days
-mike | |
|
InSight ?
