AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Ez guide 250...no signal/gps
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
jim cema
Posted 6/7/2019 07:26 (#7545832 - in reply to #7545780)
Subject: RE: Ez guide 250...no signal/gps



Jefferson MA
The switch should have no effect on the issue.

I'd suspect an antenna problem or antenna coax cable problem.....assuming you are outside and have waited 5 minutes or so before you took the picture.

Check cable and antenna for obvious damage, try another cable or antenna if you can find/borrow one.

There was a new firmware load for this system last fall, One of the things it fixed was the GPS week issue, but if your system worked a few weeks ago, that doesn't seem likely to be the cause.

May have to go in for repair. Trimble no longer deals with consumers, but route you through regional distributors.

Good luck

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)