Leene - 1/29/2019 08:21
You will need RowFlow to do row clutches (harnessing depends on type of clutch). RowFlow also runs hydraulic drive. I would advise to have 3-5 weigh pins which need Rums on those rows with a couple lift switch. You will also need a SeedSence module to monitor seed data. You can use JD or Precision hydraulic drives. JD needs a sensor installed which comes in the harness kit. Hope this helps.
Yea I know I need the CCM and the Rowflow module box as well as harnessing. I already have a Gen 1 20/20 with seedsense and 3 weigh pins on our 16/31. I don't have a lift switch hooked up but I think there is one on there that I remember seeing.
Thanks for the info on the hydraulic drives. That's nice to know. Definitely helps me out on that part.
Still trying to figure out what clutches to turn to. Someday I suppose I could do pneumatic air bags since they are cheap take off. So air clutches wouldn't be out of the question. | 
Adding clutches/hyd drive to Gen 1 20/20
