|
North Dakota | If you have the stand alone harness for the planter there is a 5 pin connector on the harness for GPS that you can plug into. Or modify a standard serial cable to plug into the 9 pin on the back of the 700. Pin 3 is TX, pin 4 is TX and 5 is ground on the 750 the serial port on the 700 is standard. You will need to turn the GGA at 5hz and VTG at 1 or 5 hz, 38,400 baud and 8n1. If your correction source is good enough you can use section control or row shut-offs if it has them.
The speed for the planter should be set up as planter/GPS. That will take the planter speed first then if the wheel sensors are bad it will use GPS as a backup. | |
|