AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Raven nh3 controller
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
tedbear
Posted 1/10/2018 07:28 (#6493391 - in reply to #6491894)
Subject: RE: Raven nh3 controller


Near Intersection of I-35 & I-90 Southern Mn.
It did not come that way from Raven. Here's a thought, as you have found all the wires that are needed are present in the 16 pin connector. This includes power/ground. It is quite common for the power pin on the tractor side to get corroded. I believe this happens in the off season since that pin is wired "hot" and corrosion takes place between it and and a neighboring ground pin.

My thought is that this may have happened to the previous owner and they just wired in another power source to go around the bad connector on the tractor. Since the split loom can be opened, I would open it up and find where that yellow and white wire go. If they are spliced onto a red and white wire then my suspicion is likely correct. If they splice to other wires report back their color. Maybe this yellow and white wire just come out on the other end for something as simple as an implement light. In Raven's color scheme green and yellow are used for the control valve.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)