SWMN | litle80 - 1/8/2018 18:51
Polarity is not an issue. Have run many Agco cable drive with an Ag Leader. At most you will need an adapter to get the wiring flowing correctly. With properly made adapters, you won't necessarily need 2 modules. Unless you want single row clutch control. If 2 rows per section is acceptable, you just make the adapters appropriately. Email in profile is good if you have any further questions.
I'm drawing a blank but I don't see your email. Curious to what adapter you would need? I would understand a merger harness of some sort to get by with one module. I still haven't seen this planter but if it has the 6pin WPs coming from the sections would it just plug in the harness (and the appropriate harness on 2nd CCM) in the diagram I've attached? In my mind it looks like pin 1 is powered then the module sends out Single to each section to complete the circuit when clutched? Different than Rowflow, but still fires the clutch it sounds like?
Edited by chaset 1/10/2018 11:30
Attachments ---------------- 4001086_wiring_schematic.pdf (68KB - 146 downloads)
|