|
| hi, step one just check your software for full functionality but basically the gen4 has swap track functionality permanently,
with it you can create a track set to suit each paddock, for example if the paddock is called A1 you can set up a track set called A1 which would have all the runlines associated to that paddock.
on your guidance page go to SET TRACK
from there you will see NEW TRACK SET down the bottom
from there you can create a track set, change the name at the top to which ever field you are in eg field A1 track set name A1 then select all the run lines you want to associate with it.
when the driver changes paddock make sure they change the track set to the associated name, this way only the run lines you have set for that field will populate.
not exactly what you want but means less chance of a incorrect runline
hopefully this helps somewhat | |
|
John Deere Gen 4 Command Center question
