Posted 4/20/2017 06:11 (#5972686 - in reply to #5972598) Subject: RE: Trimble field iq implement lift switch? ?
You can pick any module for a lift switch, it doesn't matter.
Just make sure in the setup for that module you tell it to look for the lift switch. Then it has to be calibrated under FIQ calibration.
Confirm the Deere switch is just a simple N/O or N/C switch, and that it doesn't have a funky ohm load. A simple open and close switch is what it is looking for.
Trimble field iq implement lift switch? ?
