|
| Shield- pop the plastic rivets out and it will telescope together, clean the dirt off before sliding it. Helps to also index the shield to find the holes on reassy.
Driveshaft- Unbolt the cross from the yoke that goes into the tranny, lightly pry between the yoke and cross to seperate the two, lower the end of the shaft to the floor.
Tranny yoke- The yoke will easily pull off the shaft, a slow steady flow of oil will follow. Be sure to have a new seal ready before pulling the yoke out. I have used a shopvac placed over the tranny oil fill to keep the oil from leaking out whilst installing the new seal. | |
|
Leaking 7140
