|
roaming | If you're running guidance through your Pro600, then you're running AFS AccuGuide, which uses the same nav controller hardware as a Trimble Autopilot system (which is actually T3, not T2). And you are correct that the GPS is coming into the display on the CAN bus (you can verify this by going to MAIN >> TOOLBOX >> GPS).
Since you're running RTK, both ports on your 252 are being used, so you don't have an open port to send NMEA out. But you should still be able to get NMEA out of Port C using a splitter cable. You may already have this cable installed. If your RTK radio cable has a serial port T-ed into it, you should be able to configure Port C to send NMEA out on this connector. | |
|