Viewing a thread - Need help plumbing Hiniker Anhydrous heat exchanger.

Forums | Classifieds (57) | Skins | Language

You are logged in as a guest. ( logon | register )

Need help plumbing Hiniker Anhydrous heat exchanger.	View previous thread :: View next thread
Forums List -> Machinery Talk	Message format

rebuilder

Posted 4/26/2013 06:30 (#3063799 - in reply to #3063283)
Subject: Re: Need help plumbing Hiniker Anhydrous heat exchanger.

Bourbon,Indiana

Yep, that is how mine is set up as well. I only run four knives (on 60" centers) for 8 rows. Since I have a lot of extra outlets I run double lines to each knife row, which I then Tee into one 3/8 running to the knife. I use opposite outlets on the manifold...those that are 180 degrees from each other.....to pair for each knife. So I have 8 hoses for the rows, two hoses running from the manifold to the cooler, and the two 1/2" vapor lines running to my outside rows (knives with 3/8" & 1/2" tubes.

I have sent a pic from last year which will hopefully help.Edit: note the two brown colored (old) lines running from opposite sides of the manifold to the cooler. I had the rate valve go bad so ended up having to switch out flow meters, valve & upgraded to the newer computer from Kelley.

Also. here is a diagram from Kelley Engineering showing how to set up the unit. http://www.kelleyeng.com/NH3_Diagram.pdf

Hope this helps.

Edited by rebuilder 4/26/2013 06:44