|
NC IA | Thanks lukerduke. I thought that was the situation. I have a solution - put the GSD and Processor in the cab, but that's not exactly a "clean" installation.........
StellarSupport never mentioned anything about what you described being an issue, though - even when I described exactly what I posted here.
That's why I posted it here - this is a great source of information.
How can I tell if the Starfire is "SF2 Ready"?
If I update to the latest software does that make the receiver "SF2 Ready"?
Or is that something that needs to be done with a password upgrade or Keycard update?
I would assume that would cost something at that point then too...........
Thanks again.
Ben
| |
|
JD Starfire iTC NMEA Output Problem
