|
| We have a 21 knife applicator on 30" spacings (52 1/2') and are wanting to apply 200# actual at maybe 7 MPH. We are using a Raven controller and a Continental heat exchanger. We have 1 1/4" plumbing from the tank with a full flow coupler. We typically pull single 1500 gallon tanks plumbed 1 1/4". We are thinking about adding another Continental heat exchanger and recombining the flow before the flow meter and servo valve. Can we achieve our objective? Will using two heat exchangers increase our capacity? We tried two Hiniker heat exchangers in the past on another bar and it wasn't very successful. What size plumbing to the tank? Any ideas would be appreciated. TIA | |
|
NH3 rate controller setup (need more capacity)
