|
| Ravens are pretty easy. First I would say read through the manual to find out about the things it can do. You can set a min. GPM, hold done the vol/min for 3-5 sec, min vol will flash, press enter, enter you min gpm (I think i use around 18, but it depends on nozzles and boom) then press enter. Now if you are going say 2 mph, it with still spray 18 GPM to keep the pattern/pressure. You can enter a tank vol. that will count backwards as you spray. Scan, raven shows gpa that is being applied, then us can pick what you would like to see on the other side. Hope this helps. Just remember "Enter" then put in the values you need, the "Enter"
Edited by the_jack_82 2/23/2012 19:20
| |
|
Spraying with a Mid Tech ARC6000 to Raven 460 thoughts
