|
| As per the earlier post, I did previously try turning it off and it didn't help at that time. Messing around with other stuff on the fm1000, I noticed sometimes it won't take a setting until restarted. As FRMLPLR (I'm slow and can't figure out what that stands for) seemed insistent, I tried it again today and after changing settings, turned it off, waited and restarted the FM1000. I can't give a real good evaluation because I was pulling a 51ft fertilizer applicator, and then a 58ft harrow. At few times I had it kick off, but it didn't load up with code 49's. When I seed the piece with the 36ft drills, I'll know more if it worked or not. When I start discing with the 18ft disk on the 140acre piece, I'll really know if it worked.
I appreciate the thoughts.
Art
Edited by Art Swannack 5/2/2011 20:27
| |
|