I don't know if I can..... I gave up on the FW Surface design right off the bat after the FMX locked up twice trying to lay my first main. I figured it to be the amount of topo points across the field causing me problems. I'm not sure if the section lines had topo data to them too or not. I couldn't figure a way to get just the background of my design to show without the points so I started a new blank field that resulted in no data for the field. I then just logged a section line, designed parameters, and installed. This is not the method I intended to use, but allowed to plow to keep moving. After accumulating 20-30 lines though....things slowed down. Maybe this isn't what you asked....I tried though. I'm curious on more specifics you use to make the FW Surface work though. How much data/lines do you load for the day? If I could just get a background image with no survey data I would be remotely pleased. Do you know where I can get a clean V4.0 downloaded since the V4.0 I have will not load/update? |