Posted 9/26/2010 21:57 (#1375432 - in reply to #1375192) Subject: RE: CIH 1063 cornhead bearing question
Glasgow, Ky
Just finished putting the water pump bearings on our 1063. Got parts from A&I. Right hand stalk roll bearing mounting bracket would not align and had to enlarge the holes on the cornhead frame. Also, the shaft on the nose piece had to be ground down a little to make them fit in the bearing. Most or all parts were made in Turkey. Looks like quality control is not one of their strong suits.
CIH 1063 cornhead bearing question
