Posted 9/11/2010 06:08 (#1355006 - in reply to #1354439) Subject: Re: Timken oil filled tapered roller bearings - info?
yup, I think I would put a sleeve over the 2 inch round shaft, put on a 2 1/2 inch ID bearing. The four bolt flanges that bolt on right now would not work obviously, would unbolt the holder, get welding shop to make me new brackets to hold the larger sized cast block. Pillow block might work as well, might be easier. Would have to check into it. If I ever get around to it. :)
Timken oil filled tapered roller bearings - info?
