|
| Your update issue sounds like you have a previous software version on your card. If you used another card to do a current update or if the dealer did it, once that update card is removed and your card is put back in, it will automatically detect that there is a different version than that is currently installed and it will want to install the version that is on your card. To correct the issue of an update message appearing again, put the card in your home PC and remove the RCD file and put it on your desktop, leave everything else on the card and farmat the card using a FAT32 format. Then drag the RCD file back to your card and you will be good to go. The RCD file has all your setup data. As far as your wiggles, if this is an intergrated steering system, you need to check with your dealer to see if your SSU controller needs updated. Unfortunately, it requires an electronic data link (EDL) to hook up from your sprayer to their laptop and connected to Service Advisor to upload that payload into your machine. They will need your machine serial number so they can search for any payloads available for that serial number only. Hope this helps and good luck! | |
|
iTC Reciever not detected after 2.6.1318 Update
