|
North East Indiana | 1- Atu will not recognize seat switch on the CAN Bus. You will need to set it for Activity monitor.
2- You will be able to see yield info on the GS2 if you select the proper home page. You will also need to set-up the documentation on the GS2, it will not read yield unless your mapping.
3- There are no 2-4 pin connectors in the headliner. if you bought the PF90643 kit there is a wiring harness in that kit that will plug into the terminator that is in the overhead panel.
The way you have it hooked up is the way I hook up 95% of the ones I install. If you have a issue with the Atu kicking out, especially at night, you may need to connect to the terminator. I have only had this issue on 00 and 10 series. Don't forget to calibrate your TCM and set the Atu to Harvester. | |
|