AgTalk Home
AgTalk Home
Search Forums | Classifieds (112) | Skins | Language
You are logged in as a guest. ( logon | register )

Ag Leader Integra split variety setup
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
OettingAgService
Posted 5/21/2023 12:32 (#10237731 - in reply to #10236411)
Subject: RE: Ag Leader Integra split variety setup


West Central Missouri
posse_99 - 5/20/2023 10:33

I have an Integra with multi product unlock. I'm using it with a seed tube monitor module, and a liquid product control module for infurrow. I want to run 2 different corn varieties, one in each half of my 12 row 7200. I know from reading here if you have a hyd drive, Integra needs to see 2 drives to do 2 varieties. How do you do it if you are not running hyd drive through the Integra? Either ground drive, or like I am with having my 20/20 row flow do the clutching and hyd drive.


Seedcommand handles rate control planters differently from just section control planting. In your case, your not even section control (as far as the Integra is concerned), you are just mapping, so the only limitation you should be subject to is no more than 3 hybrids total on the entire planter.

Were you a rate control planter, you would be limited to each rate control section needs to be the same hybrid. Hybrid type must be consistent through the entire rate control group.

Were you a section control planter, you would have the limitation of each section must be the same hybrid (i.e. if row 1 and 2 are on the same clutch section, they must be mapped as the same hybrid). Hybrid type must the the same through the entire section control section.

You will need a dual hybrid planter configuration. I have never done this on a "mapping only" planter configuration, but I see no reason it should not be possible.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)