|
SESD | Have a Deere 850C II on a tile plow. The drive is acting weak and erratic. The last couple days, it would start out normal. After working for a few hours, it would start getting real weak in reverse under no load, and last night, it wouldn't hardly pull in forward the last couple runs. Shut it off for an hour, and then it pulled the last line in fine. I have been noticing it has been struggling turning in reverse this fall when I got going tiling. In my opinion, it has never seemed to have the power to the tracks it should. Seems it should spin the tracks under hard pull, but it just gets weak and stalls out if it's real tough.
I know there is a relief in there and also know the hydro's can go bad, just not sure what else to check or if these symptoms point to either of those. Almost seems like a screen or something in there gets plugged and restricts flow. Had it in the shop less than a couple hundred hours ago and they said everything was fine. 6700hrs. | |
|
Diagnose Deere dozer weak drive symptoms
