|
| I have an older 6430 sunflower 31' finisher which seems to a good job especially at low speeds, but anything over 6mph and instead of being pretty flat it leaves waves going across the machine - like trash was hanging up in the harrow. I tried setting the tongue pins differently (where they pivot at the mainframe) and it appears level going through the field. I've noticed my spikes on the harrow are getting shorter, but I don't know their original length (5 bar, but pretty tight rank spacing). Anyone else have this issue and what was the fix?
Thanks,
Pat | |
|
wavy ground after finisher goes over it.
