|
| I posted yesterday about a problem Honda engine on a pressure washer. I replaced the ignition module today (as suggested by Jon Hagen) and it is running much better. Not perfect, but much better. I do not have a service manual and was wondering if anyone knows what the gap should be between the ignition module pickup and the flywheel magnets. I set it with a sheet of notebook paper and the engine is running but I don't know if this any where near correct or not. Also I removed the governor arm from the pivoting rod and was wondering if anyone knows the proper procedure to adjust the governor linkage. It seems to be off a little.
Thanks again for all the help.
C.Elliott | |
|