|
Butterfield, MN | Parameters for the steering calibration are stored in the node. I'm making an educated guess on this, but I think you'll get the message you're getting as long as the communication is going back and forth between the Cruizer and the node on the line labeled "Display" plugged into the back. Do you still have the steering setup screen available in the tools page? If so, I think it's down to the communication on the GPS side, since that's where the guidance information gets sent back and forth from the Cruizer to the node. I'd double check and make sure that both ports A and B are set to 115200 baud, and that the GPS plug heading out to the node is plugged into port B instead of port A. That really should be the only other option, since the Display should be plugged into port A, but still worth double checking. | |
|