bought a drill to do cover crops and the monitor is an old loup drill monitor. it appears to be the oldest one they have on their support page. it appears to work like a kinze muxbus system. when i turned on the monitor originally it locks up. if i unplug some sensors it will start looking for them like it should after a repower. i have blockage sensors failing here and there and shaft speed sensors that are failing at startup. its a mess.
was wondering if anyone was aware of a low cost blockage only type monitor? also curious if anyone has seen a blockage only type monitor work on an agleader monitor. it would appear this is similar to kinze systems. curious if an agleader KPMM has been setup before with a couple population sensors and also utilize blockage sensors on the rest of the rows?