|
western Ky | Well I wired my clipper foot switch from granger to an old printer cable with a db 25 connector. I cut the printer cable in half conected the wires from pin 10 and 11 to the switch normally open. I stretched the insulation back up over the ends of the remaining wires and taped them up.
When I connected the switch to the ez steer box and turned on the ez guide I got the red message page saying high voltage and the ezguide is getting hot.
Can someone please help me out here . This foot switch is really getting to be a pain!
Edited by tonka 5/11/2009 22:36
| |
|