|
Northeast Nebraska | Second implement tab is all blank. There is no implement guidance selected, and I do not have a deer receiver or the harness to try running it on a deere receiver. The tractor is wired with a ag Express 2630 HD isobus harness. GPS is fed into the serial connection port on this harness right behind the 2630 from Port B of the AG leader 6500 globe harness. Agleader 6500 port B baud rate set at 19,200, 5 hz gga, rmc, gsa nmea strings. We are running terrastar c on the AG leader globe and when we have the terrastar c correction turned on the 2630 says it's rtk, when I disable terastar c and just run it on waas, the 2630 confirms that it is waas, switching between waas and terrastar c has not affected this problem. Also from the AG leader 6500 globe harness there was a speed out connection point on the harness that gives simulated radar speed and I have that connected to the radar connector on the isobus harness. The planter is using the simulated radar ground speed from the globe for a ground speed source and it matches up perfectly with the tractor display speed as well as the AG leader steering display speed. The 2630 is only using the GPS signal for the mapping and section control.
Edited by baier91 4/25/2021 12:28
| |
|
problems with a deere 2630 fed gps by agleader 6500 while planting
