|
NW Ohio | Here is the support bulletin less the pictures.
1. Power on the AgGPS 542 GNSS receiver.
2. Press Enter twice to Mode setting. Then press the up or down arrow keys to set Mode as Radio:
3. Press Enter until Radio Config setting. Then press the up or down arrow keys to set Radio Config to Repeater:
4. Press Enter until Radio Repeater setting. Then press the up or down arrow keys to set Radio Repeater to the position number of the repeater(for example, Repeater 1, Repeater 2):
Edited by Dogface1SG 4/6/2021 10:09
| |
|
Using a trimble AgGPS 542 for a repeater.
