|
Michigan | I checked and the Imd is running 2.01 and the Sam is 1.04 so I should be okay there. My display is running version 7.5 from October 2015. Should I update? Not sure I know how to do that.
Also, I discovered today that when I get the "imd disconnected" error that I can get it to connect again by tapping the imd with the handle of a screwdriver. The 12 pin connector seems okay, wiggling that doesn't do anything.
Could this be causing all the Sam errors or do I have two separate problems?
I will send you an email tomorrow morning--typing this on an iPad that doesn't have email set up. Thanks! | |
|
Trimble 750 / EZ Pilot problems
