AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Trimble 750 / EZ Pilot problems
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
premoj
Posted 5/19/2017 08:53 (#6024669 - in reply to #6023747)
Subject: RE: Trimble 750 / EZ Pilot problems



Here is what the FM750 7.71 firmware says in regards to the ez-pilot:

Guidance Issues
o EZ-Pilot re-initialization after initialization ground fault reported
o EZ-Pilot motor speed settings now recover from low voltage fault during system initialization
(System fault addressed in this build)
o EZ-Pilot IMD-600 firmware v2.01 now available to address accelerometer shock recovery and temperature offsets


I also included a copy of the ez-pilot quick reference card pertaining to cabling. You can see where the terminators are located.

I have a couple other ideas to try yet, that we can talk about later.



Edited by premoj 5/19/2017 08:59




Attachments
----------------
Attachments fm750 ezpilot QRC.docx (206KB - 23 downloads)
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)