|
Fairbury, NE (Southeast) | Build one with the wire roll laying sideways....that way you can go around slight bends without the wire rolling off the edge of the spool. Build one from 2 inch O.D. square stock and a 24 inch stick of 1" diameter sucker rod. Disk blade on the bottom. Fits in the receiver hitch of the pickup or four wheeler. Takes 5 minutes to roll a 1/4 mile out. Then attach at a few spots and roll the next one.
Custom fence guy has one set up to do 4 rolls at once. I don't consider myself that talented.
Edited by dt4020 11/3/2014 20:53
| |
|
Barbed wire unroller
