Alsace 47°52'46"N 7°24'30"E | Hi, there are a few parameters to check first when programming your pannel:
- length of the pivot
- time to make a full rotation (360 °)
- quantity of water that feeds the pivot (i think in GPM)
- Pressure of water
- check that the water outlets (sprinklers, rotators, sprays, end guns) are dimensionned according specs or else you could be over irrigating on a section while under irrigating on another. The farther you are from the pivot center, the more water has to go through the outlet, so be sure nobody has messed with the outlets.
- As you are programming a Cams Pro, make sure you are programming the right sequence: the CAMS Pro accepts a lot of different irrigation sequences that you can preprogram (one for wheat, one for corn, one for forward, one for reverse, etc....) So be sure that you monitor the sequence you are programming: this sequence must be active! Keep us posted on your experience.
Edited by MikeInFrance 7/20/2006 13:48
|
Irrigation
