|
Wardview, LA | Thanks guys. After reading the posts last night and going over in my head when I saw the steering shake versus when I got back down to my farm, I am a little embarrassed to say it was as I was unhooking the disc I borrowed where I had both remotes in float position. I unhooked and drove to the ditcher (100 yards) where I had forgot to undo the remotes in the float position as I was hooking up. After I remembered to correct the float, I am not sure that I ever saw the steering do that again. The 3 point still shakes some but needs a seal kit in the cylinder. Is this normal?
I believe I am still going to replace the hydraulic fluid, filters and clean the screen along with confirm scv pressures especially since I plan on restoring the tractor this winter.
If it is a high pressure leak, where would the most common places be?
Edited by warrior-p 11/14/2012 09:53
| |
|