|
East Central, Nebraska | i run a gandy with a AL strip till module which is little to no help in your situation but i will say that its basically a raven system if that helps any. its a raven servo valve, raven speed sensor....
i cannot run the clutches with my ag leader system as it sits. those clutches are kind of a high power deal. i am sure they could possibly work or would surely work with a relay but i dont even use them. i have them tied to a simple on/off switch that sits behind the seat and i turn them off at night and back on in the morning. the section control turns the drive on and off which works okay for my situation. i will say a down fall to the whole system is that its slow to get going when distributing product. they start pretty slow and take a second to get up to speed. on the rig that i have the gandy box its only an 8 row and i typically shut the section control off and just control it from the master switch which gives me a chance to shut it off and then turn it on extra early so they are running up to speed when the machine hits the ground.
long story short, it works fairly well but other systems perform better. i think if the automatic section control is setup with plenty of look ahead it could work great but i don't think i would get too worked up about the clutches unless your running a real big rig and even then its just a half section clutch.
Edited by caseihfarmer 7/1/2026 15:58
| |
|
Deere Dry RC on Gandy Air Seeder
