I use a Precision Planting Gen 3 2020 to control my planter. I have a globe on the planter and have it set up to record for AutoPath with my G5 display. I have it set up to record a tillage pass. This is the 3rd year I have done this. I've gotten along fine. This year, I planted for a neighbor that has the capability to use AutoPath in his sprayer, so I thought I'd record for him and export the Tillage (planting coverage) pass so he could get it into Op Center to make AutoPath lines. My fields work fine, his do not. I can go in to save a Work Plan in my fields and it will see my Tillage/Planter pass and allow me to generate AutoPath lines from it. When I attempt to do the same thing on his fields, it doesn't fine any compatible passes to generate AutoPath lines from. I can clearly see the same Tillage/Planter layer on all of his fields as I have on mine. There is a link to a help page that I've pasted below. Even though it says a Planting source operation is required for spraying and harvest, I can make AutoPath files for spraying and harvesting in my fields. I did merge some of his fields with the corresponding fields I had set up for him in my Op Center so they would be named the same in both his and my Op Center accounts. But even after merging, the three layers I recorded are there (the tillage/planter layer I recorded with my G5, the planting layer with the population/variety/planter performance info, and the starter layer). Igot Panarama and had it sync the data over to Op Center, which worked good. But again, I did the same thing on my fields as I did on his (other than merge the fields I had for him in my Op Center account with the ones he exported and I imported in my Op Center.