I can take some pictures later. I had a Raven 660 on my Willmar spreader, literally just took the harness off yesterday and had a guy install a custom harness for a John Deere Dry Rate controller. I have a bracket and shields draw up that I had made to mount the hydraulic motor and shield it and the chain. I've seen a bracket welded to the spreader frame, but I wanted to have it so it wasn't hard to remove it and convert back to ground drive if someone wanted to. I also wanted to keep the existing slip clutch in the driveline, some of the ones I've seen are direct drive.

(Willmar Spreader001 [640x480] (full).JPG)

(Willmar Spreader002 [640x480] (full).JPG)

(Willmar Spreader004 [640x480] (full).JPG)

(Willmar Spreader005 [640x480] (full).JPG)

(Willmar Spreader008 [640x480] (full).JPG)

(Willmar Spreader009 [640x480] (full).JPG)

(Willmar Spreader012 [640x480] (full).JPG)

(Willmar Spreader013 (full).JPG)

Willmar Spreader001 [640x480] (full).JPG (77KB - 17 downloads)

Willmar Spreader002 [640x480] (full).JPG (71KB - 14 downloads)

Willmar Spreader004 [640x480] (full).JPG (72KB - 11 downloads)

Willmar Spreader005 [640x480] (full).JPG (72KB - 12 downloads)

Willmar Spreader008 [640x480] (full).JPG (68KB - 11 downloads)

Willmar Spreader009 [640x480] (full).JPG (75KB - 11 downloads)

Willmar Spreader012 [640x480] (full).JPG (68KB - 9 downloads)

Willmar Spreader013 (full).JPG (97KB - 8 downloads)