|
Ohio | We have a MT865C with Trimble guidance system instaled on it with CFX-750 with NAV Controller III.
Earlier was instaled an TopCon guidannce system....
The system works fine no errors occured.
Only one problem when turning the vehicle in backward speed the tractori icon on monitor is turning arround like it should be but when turning again in forward speed the icon on screed
may go backward or may start spinning or may go sideway.
Changed all Trimble Hardware monitor changed to FMX.
NavController Changed.All cables Changed.
We have made an upgrade of armrest console and of the C1000 terminal...
Could not upgrade other controlers with EDT there is needed CAT ET which we don't have .....
Checked all steering and transmision sensors everythink works fine.....
On Trimble hardware changed all posible firmware....
Changed signal tipes from RangePoint RTX to RTK
See Video in atatchments....
Edited by vasile123 7/5/2018 06:05
Attachments
----------------
 Challenger 865C.avi (3351KB - 176 downloads)
| |
|
Challenger MT 865C Trimble CFX-750 heading spinning
