|
Malawi | The c series did not come with the beeline system so the only controller under the roof is the lighting controller on the rear right. Your connection to the can bus is a "t" into the aux bus cable just below the fuse boxes down at the floor mat? That's where our FMx units are connected but we use them for levelling not steering.
Did you set up the nav controller through a laptop or via the screen? When I installed a couple of Cfx units with the new autopilot electric motor drive I used the laptop to configure the nav controller. It had more options than was shown on the screen.
Stupid question but I assume the top dock was removed? | |
|