|
| I have a 26 - maybe 28 ft 980 that the rephasing cylinders were shot on it. New deere cylinders were gonna cost more than the whole rig was worth so i put common two way cylinders on it. Mine had 3 cylinders. One for the center section and one for each wing. When all hooked together they wouldnt raise or lower at the same rate. I ended up putting the center on its own hoses and the wings together on another set of hoses and then i can even them up with the hyd flow control on the tractor. I use stops for depth control. Its not too much trouble this way. Once its adjusted right you just flip 2 switched instead of one to raise and lower the rig.
Tom
NE ARK
Edited by tc034 7/1/2016 12:19
| |
|
|