|
East Central Ia | Those tanks look like a slick setup!
I will keep an eye on the pressures tomorrow. My tank pressure should be very close to my pressure gauge that is installed after my coolers but before my control valves... If not I have a tank supply issue I assume?
Either way by what info I could find online tonight 2% of tank capacity seems to be a pretty good rule of thumb for maximum tank withdraw rate in gpm?
So 20-25 gpm for a single 1000 gal tank
30-35 gpm for a 1500 gal tank?
I pull mostly 1500 gal tanks.
This is the only pic I have of it atm. I just want to figure out what I need to do to add 2 more knives and maintain a 7.5 mph speed at 200# actual. That would be my max rate.
Edited by bleedred 4/11/2014 23:50
(20140319_094219.jpg)
Attachments ---------------- 20140319_094219.jpg (85KB - 84 downloads)
| |
|