just a tish NE of central ND | Bad driver on the blower fan housing. Picked up a new one and started throwing parts at the problem and got lucky. The new driver is different and instructions were about non existant. The old one is screwed to the fan housing.Removi9ng it leaves a 3 x 4 inch hole wide open. The new one is bigger and different shaped. I screwed it to the rear'firewall" and put the old one back on the blower to plug the hole. Most of the connectors fit but I had to splice the blower wires to the driver harnass as the plug ends were different and I didnt get a conversion harnass, nor did I see one reccomended for it. zip ties came into play as there was plenty of wire extra.
Edited by School Of Hard Knock 5/23/2018 22:58
(20180513_205848 (full).jpg)
(20180513_210129 (full).jpg)
(20180513_212008 (full).jpg)
Attachments ---------------- 20180513_205848 (full).jpg (202KB - 30 downloads) 20180513_210129 (full).jpg (206KB - 26 downloads) 20180513_212008 (full).jpg (127KB - 23 downloads)
|