|
| In the GS2 diagnostics it is showing "1" even though the system isn't applying.
The center section acts the same way. If you start straddle of the skip, the middle section won't come on until a wing section comes on.
Not sure about the harnessing brands, but it could very well be a physical connection instead of software. The valves are Raven valves though.
The SCP settings are set for minimize skip on all three (including coverage overlap).
It has shown up this was since day 1. It seems (but I couldn't swear to it) to only do it out headlands. If I just ran cross way in the field I think it would come on ok, but it's only out of the endrows, IF it's set down in the previously covered area (if I set it down a little late it seems ok).
Thanks. | |
|
- GS2, Swath Control delay... still going on - younginitiative : 5/26/2011 10:12
- Re: GS2, Swath Control delay... still going on - mcline : 5/26/2011 15:14
- RE: GS2, Swath Control delay... still going on - younginitiative : 5/26/2011 15:21
- Re: GS2, Swath Control delay... still going on - mcline : 5/26/2011 15:34
- Re: GS2, Swath Control delay... still going on - younginitiative : 5/26/2011 15:39
- Re: GS2, Swath Control delay... still going on - mcline : 5/26/2011 15:53
- Re: GS2, Swath Control delay... still going on - younginitiative : 5/26/2011 16:06
- Re: GS2, Swath Control delay... still going on - younginitiative : 5/26/2011 18:07
- Re: GS2, Swath Control delay... still going on - mcline : 5/26/2011 18:53
- Re: GS2, Swath Control delay... still going on - younginitiative : 5/28/2011 14:52
- Re: GS2, Swath Control delay... still going on - younginitiative : 5/29/2011 00:49
|
GS2, Swath Control delay... still going on
