|
| Hey everyone, I'm new to AgTalk. I've been working to create VRT maps for lime spreading this fall. I've been exporting them from Agvance using 'Agco Falcon TIFF' format to go into the Falcon II controller. I'm able to see the folder that contains the data on the floppy disk but can't seem to make any of the data physically appear on the monitor. I thought I was getting somewhat close to figuring it out but received the message about Dealer ID. I'm hoping the pictures may have jogged some of your memories as this isn't exactly new technology. Thanks in advance for any advice you guys may have for me.
Edited by twehri 9/10/2020 15:04
 (IMG_0135[1] (full).JPG)
 (IMG_0136[1] (full).JPG)
Attachments
----------------
 IMG_0135[1] (full).JPG (96KB - 266 downloads)
IMG_0136[1] (full).JPG (98KB - 306 downloads)
| |
|
Agco Falcon II Shapefile Import
