Near Intersection of I-35 & I-90 Southern Mn. | dpilot83 - 4/4/2009 19:43
Thanks for your help. I'll do that. I'm planning on running Deere Implement switches. I see the diagram also has part number 2000453-2 or -3 (depending on length) as extension cables. Is there any reason I can't make my own extension cables? Thanks.
The extension cables are simply two runs of wire with weatherpak connectors on each end. There is nothing tricky about these cables at all. I generally make the ones for our installs at the store as I then make them the correct length.
To use more than one implement switch is easy also. Pin A out of the module is 12V. Split it and run it to each implement switch. The returning wires from the implement switches are joined and fed to Pin B.
Again nothing tricky here either. The switches are in parallel so if one, the other or both are closed the system will plant. It will only activate the clutches to disengage them if all switches are in the non-planting position.
Edited by tedbear 4/4/2009 22:18
|
Cables coming out of Seed Command Clutch Control Module
