| TS79 - 5/24/2020 10:40
Did it indicate it was on grade on the display when it was actually off grade?
The backhoe sitting in the line of sight is likely not an issue.
Did it work fine after that?
That's the weird part, it acted like it thought level was on grade. So it didn't dive, it just didn't follow the ground profile. This whole time it was reading on grade, maybe low 0.1 inch.
It started this one run, which I finished by manually running the plow, yes we had that much slope. I ran three blank runs and it acted the same all three. Decided to pack up so went to the base, tried one more time, and it acted correctly that last one.
Normally the screen would show a ground line, a target line and a maximum depth line. During these trial runs it didn't seem to show that. |
Gradient intellislope
