AgTalk Home
AgTalk Home
Search Forums | Classifieds (172) | Skins | Language
You are logged in as a guest. ( logon | register )

Any tips on getting this apart
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Dozer
Posted 5/23/2020 17:48 (#8275720 - in reply to #8275612)
Subject: RE: Any tips on getting this apart


Southern Iowa
I did a lift cylinder on my D6c recently just like you're doing....big pipe wrench, 4' extender pipe.
Pull out the locking set screw, if it has one, heat with torch... not super hot.

Tilt cylinder was a different story...ended up having to take it to Cat because there's nothing to get a solid gold on to. Their hyd bench didn't even know it was doing anything.
Said they routinely torque stuff to 16,000 ft lb.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)